Important read mounting instructions below before you buy
Leadfinger Racing introduces the new bruggy body for the Tekno NT 48 2.0!
The nitro version of the new NT 2.0 bruggy body features a large cab with an intergraded stabilizer and down force. Added air dams to the side pods that increase overall handling capabilities and feel. The rear fin has been raised to help provide more level jumping and assist traction.
The new bruggy body from Leadfinger Racing for the Tekno NT48 2.0 comes with window masks, front grill, and headlight stickers. LFR logo stickers also provided.
Made in the USA by Leadfinger Racing
*Larger cab with center stabilizer and intergraded downforce
*Air dams on side dams for better overall handling
*Raised rear fin to aide jumping and assist traction
*Body is sold clear and ready for paint
*Window masks, front grill stickers provided
*Made in the USA
*Mounting your new LFR bruggy body on the Tekno NT48 2.0*
To mount the body, you will need 2 x Xray composite rear body posts. Part # 351330
Please follow these simple steps below.
1) cut/remove plastic tabs on body mounts
2) remove wing
3) insert body posts screws were shown
4) replace wing
5) tighten down screws to body posts
Tip: as you tighten the screws hold the post level. It is a close fit. If you need too, line up the hex nut on the wing to allow more room for the post. You will not need to shave the wing mount or posts for clearance.
The reason I chose to use the Xray posts was to lower the body as much as possible for a more level look. Stock mounts are used in the stock position on the front tower. To raise the rear, simply replace the stock posts. (you will need to ream new holes in the body for this) If you have any questions, I am happy to help. Happy racing, thank you -Chris LFR Racing
